NFPA Hazard Ratings:

0=Minimal, 1=Slight, 2=Moderate, 3=Serious, 4=Severe

Emergency Overview: Organisms used are non-pathogenic, but can cause infection when in contact with open wounds. These organisms are susceptible to many commonly used antibiotics.

Potential Health Effects:  

• Signs and Symptoms of Acute Overexposure: Eye, skin irritation
• Signs and Symptoms of Chronic overexposure: Dermatitis and skin sensitization
• Medical Conditions Generally Aggravated by Exposure: Allergies, dermatitis.
• Ingestion: Ingestion (acute exposure) of ammonium slats may produce nausea, vomiting, gastric irritation. Large doses (over 6 grams) may cause systemic ammonia toxicity. Symptoms may include heavy breathing, blue skin, dulness, restlessness, convulsions or coma. DSP ingestion may result in abdominal pain, nausea, vomiting, diarrhea, shock, hypertension, slow pulse, cyanosis, coma and convulsions.
• Inhalation: (Acute) Inhalation may cause throat irritation and coughing. (Chronic) No effects reported in humans.

• Inhalation: Remove victim to fresh air
• Ingestion: Give victim water or milk to drink to dilute the product. Get medical advice..
• Skin Contact: Remove contaminated clothing and footwear. Wash skin with soap and water. Wash clothing before reuse.
• Eye Contact: Immediately flush eyes with water for 15 minutes. Get medical attention.
• Note to Physician: If patient's immune system is compromised, request antibiotic sensitivity chart from Alken-Murray Corporation by e-mail: clearflo@shentel.net

 Flash Point: > 93 degrees C (>199.40 deg. F)

Flammability Limits: NA

Autoignition temp: NA

Fire Extinguishing Media: Water spray, carbon dioxide, dry chemical

Special Fire-Fighting Information: None

Unusual Fire and Explosion Hazards: None

• Ventilation System: Good general ventilation is advisable
• Personal Respirators (NIOSH Approved): if needed, use respirator to screen out nuisance dust
• Skin Protection: Long sleeved clothing
• Eye Protection: Safety glasses if dust is raised
• Other Control Measures: Minimize exposure in accordance with good hygiene practice. Avoid handling which would create large amounts of dust.

• Appearance and Color: Free-flowing tan to brown powder.
• Odor: Yeast-like odor
• Solubility in Water: Moderate, contains viable bacteria
• Specific Gravity: NDA
• Bulk density: Approximately 0.66-0.77 gm/cm3
• pH: 6.5-8.5
• % volatile by volume @ 21C (70F): Nil
• Boiling Point: NA
• Melting Point: NA
• Vapor Density (Air=1): NA
• Vapor Pressure (mm Hg): NA
• Evaporation Rate (Bu. Acetate=1): NA

• Stability: Product is stable.
• Hazardous Decomposition Products: Contact of ammonium salts with bromine trifluoride may cause explosion. Violent reaction between ammonium salts may occur on contact with iodine heptafluoride. Ammonium salts forms unstable ammonium perchlorate in combination with potassium chlorate.
• Hazardous Polymerization: will not occur.
• Incompatibility: Acids, alkalies, high temperatures, other toxic materials may inactivate biological cultures. Solutions may be very slightly corrosive to metals.
• Conditions to Avoid: Exposure to strong acids, bromine trifluoride, iodine heptafluoride, potassium chlorate.

• Toxicological Data: (CFR Title 16, Title 1500.42)

RTECS: Bacterial cultures: 1004274VB / CAS 116469-86-4: 1012301CS/ CAS 7558: WC4500000/ CAS 64-02: AH 5075000/ CAS 7558-80-7: WA1900000

LD50/LC50 CAS# 116469-86-4: this is a natural food substance and is non-hazardous / CAS# 7732-18-5: LD50= >90 mL/Kg / CAS# 12125-02-9: oral,rat LD50 = 1650 mg/Kg, Draize, rabbit, eye = 500 mg/Kg / CAS# 7558-79-4: Oral rat LD50: 17 gm/kg. Skin rabbit, standard Draize, 500 mg/24H, mild. Eye rabbit, standard Draize, 500 mg/24H mild / CAS# 9012-54-8: Oral, rat LD50 = > 5 g/Kg / CAS# 37278-89-0: Oral, rat LD50 = > 2,000 mg/Kg

• Carcinogenicity: Ingredients not listed by ACGIH, IARC, NIOSH, NTR, or OSHA

 Environmental Fate: No information found

Environmental Toxicity: NA

• DOT Proper Shipping Name: Not regulated as hazardous by DOT
• DOT Hazard Class: None
• DOT Label: N/A

• TSCA: All chemical ingredients are listed on TSCA inventory, with no special reporting regulations
• CERCLA Reportable Quantity: None
• Clean Air Act: This formula does not contain any hazardous air pollutants or ozone depletors.
• Clean Water Act: None of the chemicals in this product are listed as hazardous, toxic or priority pollutants.
  State Right-to-Know Lists: None
  Exposure Limits: NDA
• SARA TITLE III:

..................................Section 302/304 Extremely Hazardous Substances: None

..................................Section 311 Hazard Categorization: Acute, chronic

..................................Section 313 Toxic Chemicals: None

• Canadian WHMIS Classification: Class D2B for xylanase enzyme & live bacterial cultures
• Not subject to Proposition 65 labeling requirements

16. Other Information

Reason for Revision: Formula revision, fungal cultures replaced with enzymes

Alken-Murray Corporation provides the information contained herein in good faith, in compliance with the Occupational Safety and Health Act of 1970, but makes no representation as to its comprehensiveness or accuracy. This document is intended only as a guide to the appropriate precautionary handling of the material by a properly trained person using this product. Alken-Murray warrants that this product is of merchantable quality. The implied warranty of fitness for a particular purpose is limited to the extent the products are used for the purpose or uses described on the product's label or in any written instructions or materials distributed to the buyer by Alken-Murray and is hereby disclaimed should buyer use the products in a manner inconsistent with this uses or purposes described therein. In no event shall Alken-Murray be liable for any consequential, exemplary, or incidental damages incurred by buyer even if it has been advised of the possibility of such damages.