• Signs and Symptoms of Acute Overexposure: Mild eye, skin irritation.
• Signs and Symptoms of Chronic overexposure: Discomfort, irritation of eyes and skin with swelling and possible reddening of or visible rash on skin.
• Medical Conditions Generally Aggravated by Exposure: Existing cuts, rashes, allergies or other sensitive areas would possibility be aggravated by exposure.
• Ingestion: Ingestion may result in abdominal pain, nausea, and vomiting.

• Inhalation: Remove victim to fresh air
• Ingestion: Give victim water or milk to drink to dilute the product. Get medical advice..
• Skin Contact: Remove contaminated clothing and footwear. Wash skin with soap and water. Wash clothing before reuse.
• Eye Contact: Immediately flush eyes with water for 15 minutes. Get medical attention.
• Note to Physician: None

 Flash Point: > 200 degrees F (PMCC)

Flammability Limits: NDA

Autoignition temp: NDA

Fire Extinguishing Media: Carbon dioxide, dry chemical, Halon 1211, water

Special Fire-Fighting Information: Spilled chemical creates extremely slippery conditions, especially in contact with water. Use caution. Respiratory and eye protection are required. Self-contained breathing apparatus should be used.

Unusual Fire and Explosion Hazards: None known.

• Ventilation System: Good general ventilation is advisable. Local exhaust desired.
• Personal Respirators (NIOSH Approved): None required for normal use and processes. if needed, use respirator to filter out mists/vapors.
• Skin Protection: Long sleeved clothing, impervious rubber or neoprene gloves and protective apron.
• Eye Protection: Safety glasses or goggles
• Other Control Measures: Minimize exposure in accordance with good hygiene practice. Avoid handling which would create large amounts of mists/vapors. Exxon Medical Research recommended inhalation TLV for CAS 64742-47-8 of 200 ppm.

• Appearance and Color: Light yellow slightly turbid liquid
• Odor: Mild petroleum and acrylate
• Solubility in Water: Miscible. Highly viscous solutions limit solubility
• Specific Gravity: Approx. 1.04
• Viscosity at 28 deg. C: 60-180 cps
• % volatile by volume @ 21C (70F): NDA
• Boiling Point: 210 deg. F
• Melting Point: NDA
• Freezing Point: 12 degrees C
• Vapor Density (Air=1): Nil
• Vapor Pressure (mm Hg): < 23
• Evaporation Rate (Bu. Acetate=1): < 1

• Stability: Product is stable.
• Hazardous Decomposition Products: None known
• Hazardous Polymerization: will not occur.
• Incompatibility: Strong oxidizers: liquid chlorine, concentrated oxygen, sodium hypochlorite, calcium hypochlorite
• Conditions to Avoid: Incompatible substances

• Toxicological Data:

RTECS: CAS 26062-79-3: BP6360000, CAS# 7732-18-5: ZC0110000

LD50 /LC50: CAS# 7732-18-5: Oral, rat: LD50 = > 90 mL/Kg;/ CAS# 26062-79-3; Oral, rat, LD50 = 3,000 mg/Kg, Oral, mouse LD50 = 1720 mg/Kg, Oral, guinea pig LD50 = 3250 mg/Kg. Eye & skin irritant. May aggravate existing medical conditions, such as rashes, allergies or other sensitive areas. Symptoms may include reddening, swelling of effected areas with possible itching, burning or other discomfort.

 

• Carcinogenicity: Not listed by ACGIH, IARC, NIOSH, NTR, or OSHA

• Environmental Fate:

Alken Solutions C186K BOD (Biological Oxygen Demand) = 77,000 mg/L

Alken Solutions C186K COD (Chemical Oxygen Demand) = 437,000 mg/L

• Environmental Toxicity:

Aquatic Toxicity:* CAS# 26062-79-3: Daphnia Magna, 48 HOUR LC50=0.23 MG/ L IN 100 MG/L CACO3. FATHEAD MINNOW (Pimephales Promelas), 96 HOUR LC50=6.51 MG/L IN 180 MG/L CAC03; with 10 MG/L TOC FROM Humic Acid. FATHEAD MINNOW (Pimpephales Promelas), 96 HOUR LC50: 0.3 MG/L IN 100 MG /L CACO3. *NOTE: Aquatic Toxicity is reduced by factors of 10 to 100 times in the presence of 5-10 mg/L of organic carbon, as found in most surface waters.

• DOT Proper Shipping Name: Not regulated as hazardous by DOT
• DOT Hazard Class: None
• DOT Label: Class 60:(NMFC item #4612, LTL) "adhesives, adjuvents, spreaders, sliders, liquid, in pails or drums" Alken Solutions C186K cationic polyquaternary polymer liquid
  

• TSCA: (40CFR 710) All chemical ingredients are listed on the TSCA 8(b) inventory. None of the ingredients are on the Health and Safety Reporting List, are under Chemical Test rule, are listed under TSCA Section 12B, or have a SNUR under TSCA
• CERCLA Reportable Quantity: This product does NOT contain ingredients that have Reportable Quantity (RQ) requirements under US 40 CFR 117.302
  
• SARA TITLE III:

  Section 302/304 Extremely Hazardous Substances: None Section 311 Hazard Categorization: None Section 313 Toxic Chemicals: None

• Clean Water Act: This product is considered an oil under Section 311 of the Clean Water Act (40 CFR 110) and the Oil Pollution Act of 1990. Discharges that produce a visible sheen on surface waters or on waterways or sewers that lead to surface water must be reported to the National Response Center, 800-424-8802. Product can be bioremediated with Alken Clear-Flo 7008.
• Clean Air Act : Ingredients not listed as hazardous pollutants under CAA. This product does not contain any Class 1 or Class 2 ozone depletors, nor was it made with such chemicals.
• OSHA: None of the ingredients are considered Extremely Hazardous by OSHA.
• STATE RIGHT-TO-KNOW LAWS:. Ingredients not listed on California, Connecticut, Florida, Illinois, Louisiana, Massachusetts, New Jersey, New York, Pennsylvania, or Rhode Island.
• Not subject to California Proposition 65 labeling requirements
• Canadian WHMIS Classification: None
• Canadian DSL: all ingredients listed and compliant. Product approved for sale in Canada
• Canada's Ingredient Disclosure List: Ingredients are "NOT CONTROLLED". This MSDS has been prepared according to the hazard criteria of the Controlled Products Regulations (CPR) and the MSDS contains all of the information required by the CPR.
• TDG Classification: Not regulated as hazardous by Canadian TDG.
• IHT Code: 2921.21.0000 "Cationic polyquaternary polymer liquid"
  

Reason for Revision: New product

Alken-Murray Corporation provides the information contained herein in good faith, in compliance with the Occupational Safety and Health Act of 1970, but makes no representation as to its comprehensiveness or accuracy. This document is intended only as a guide to the appropriate precautionary handling of the material by a properly trained person using this product. Alken-Murray warrants that this product is of merchantable quality. The implied warranty of fitness for a particular purpose is limited to the extent the products are used for the purpose or uses described on the product's label or in any written instructions or materials distributed to the buyer by Alken-Murray and is hereby disclaimed should buyer use the products in a manner inconsistent with this uses or purposes described therein. In no event shall Alken-Murray be liable for any consequential, exemplary, or incidental damages incurred by buyer even if it has been advised of the possibility of such damages.